Attaching the ToughPad dock and keyboard tray to the tablet mount - AutoVu™ Hardware

Panasonic ToughPad G1 dock installation

Applies to
AutoVu™ Hardware
Last updated
2017-06-05
Content type
Guides
Guides > Installation guides
Language
English

After the table mount is attached to the tilt-pivot head, you can attach the ToughPad dock and keyboard tray to the tablet mount.

What you should know

Use these steps to install the following hardware:

  • ToughPad dock: AS7.P001.100 (Genetec part number: AU-H-PANADKSTG1)
  • Keyboard tray: AS7.C100.002 (Genetec part number: AU-H-PANAKEYTRAY)
  • 4 x 3/8" flat head screws

Procedure

  1. Connect the mounting bracket (A) to the tablet mount (B) as shown using the screws that are pre-fastened to the tablet mount.
  2. On the back of the ToughPad dock, set the EXT/INT ANT switch (C) to INT.
    IMPORTANT: Do not use the EXT setting. Doing so disables the system's networking capability and the system does not function.
  3. Attach the ToughPad dock (D) to the mounting bracket (E) as shown using the screws that are pre-fastened to the mounting bracket.
  4. Attach the keyboard tray (F) to the tablet mount as shown using the four 3/8" flat-head screws (G) that are shipped with the keyboard tray.