Attaching the tablet mount to the tilt-pivot head - AutoVu™ Hardware

Panasonic ToughPad G1 dock installation

Applies to
AutoVu™ Hardware
Last updated
2017-06-05
Content type
Guides
Guides > Installation guides
Language
English

After the tilt-pivot head is attached to the tele-pole, you can attach the tablet mount to the tilt-pivot head.

Before you begin

Ensure that you have all of the required hardware:
  • Tablet mount
  • Tilt-pivot head
  • 4 x 3/4" flat head screws
  • 4 x serrated flange nuts

What you should know

You must connect the tablet mount to the tilt-pivot head as shown before connecting the keyboard tray to the tablet mount.

Procedure

  1. The table mount (A) and the tilt-pivot head should both be able to tilt towards the user. Orient the tablet mount and the tilt-pivot head as shown.
    NOTE: The adjustment knob on the tilt-pivot head might be on either side depending on how it was assembled by the manufacturer. Therefore, you cannot orient the hardware based on the position of the adjustment knobs.
  2. Connect the tablet mount (B) to the tilt-pivot head using the four 3/4" flat head screws and serrated flange nuts in the mounting holes (C) shown in the following image.