Configuring Pay-by-Plate Sync resources - Pay-by-Plate Sync 5.2

Pay-by-Plate Sync Plugin Guide 5.2

Applies to
Pay-by-Plate Sync 5.2
Last updated
Content type
Guides > Plugin and extension guides
Pay-by-Plate Sync

The Resources tab is where you configure the Pay-by-Plate Sync plugin’s server and database settings.


  1. In the Config Tool Home page, select Plugins, and then click on Pay-by-Plate Sync.
  2. Select the Resources page.
  3. Configure the settings as you would any other Security Center role.
    Failover is supported for the Pay-by-Plate Sync plugin, with the following conditions:
    • The plugin supports up to three failover servers.
    • The failover servers must have access to the parking provider servers.
    • The Security Center database must be accessible from both the live and failover servers.
    • The Pay-by-Plate Sync plugin must be installed on the failover servers.
    • All servers must be able to access the permit list source files.
  4. Click Apply.
    Pay-by-Plate Sync Resources settings are configured.

After you finish

If you added failover servers, you must enter their IP addresses in Genetec Patroller™ Config Tool. For more information, see the Pay-by-Plate Sync settings reference section.