Preparing your Echodyne system for integration with Security Center - To prepare your Echodyne devices for integration with Security Center, you must configure the Echodyne system to communicate with the Genetec™ Restricted Security Area Surveillance (RSA Surveillance) plugin. For specific details about configuring your devices and software, refer to the Echodyne documentation. - Restricted Security Area Surveillance

RSA Surveillance Integration Guide for Echodyne Radar Systems

Product
Restricted Security Area Surveillance
Content type
Guides > Integration guides
Guides > Plugin and extension guides
ft:locale
en-US
Last updated
2025-03-31

To prepare your Echodyne devices for integration with Security Center, you must configure the Echodyne system to communicate with the Genetec™ Restricted Security Area Surveillance (RSA Surveillance) plugin. For specific details about configuring your devices and software, refer to the Echodyne documentation.

Before you begin

Procedure

  1. Deploy and configure the Echodyne system as described in the Echodyne documentation.
  2. Make sure that the system state of the radar is in SWT mode.
  3. For some organizations, network security policies require that the IP devices, routers, and switches in their network block unused ports. If your organization has such policies in place, then make sure to open the TCP port that the RSA Surveillance plugin and the Echodyne system use to communicate.
    NOTE: Echodyne devices use ports 29979 and 29982 to communicate with Security Center.
  4. Take note of the IP address of the Echodyne device.
    You need this information to configure the radar device later.