Preparing your Magos system for integration with Security Center - To prepare your Magos devices for integration with Security Center, you must configure the Magos system to communicate with the Genetec™ Restricted Security Area Surveillance (RSA Surveillance) plugin. For specific details about configuring your devices and software, refer to the Magos documentation. - Restricted Security Area Surveillance

RSA Surveillance Integration Guide for Magos Radar Systems
Product
Restricted Security Area Surveillance
Content type
Guides > Integration guides
Guides > Plugin and extension guides
ft:locale
en-US
Last updated
2025-04-02

To prepare your Magos devices for integration with Security Center, you must configure the Magos system to communicate with the Genetec™ Restricted Security Area Surveillance (RSA Surveillance) plugin. For specific details about configuring your devices and software, refer to the Magos documentation.

Before you begin

Procedure

  1. Deploy and configure the Magos system as described in the Magos documentation.
  2. Make sure that the radar device is configured in the MASS Server and is operating as expected.
  3. Create an administrator-level user account in the MASS Server for the plugin to use to connect.
  4. Take note of the following information. You need it to configure the Magos system in Security Center:
    • IP address of the server that hosts the MASS Server
    • Username and password for the administrator-level user account you created earlier

After you finish

Add your Magos radars as tracking systems to Security Center.