Preparing OPTEX PIE-1 encoders and OPTEX RLS and Redscan Mini lasers for integration with Security Center - To prepare your OPTEX devices for integration with Security Center, you must configure the OPTEX system to communicate with the Genetec™ Restricted Security Area Surveillance (RSA Surveillance) plugin. For specific details about configuring your devices and software, refer to the OPTEX documentation. - Restricted Security Area Surveillance - Plugin and extension guides - Integration guides

To prepare your OPTEX devices for integration with Security Center, you must configure the OPTEX system to communicate with the Genetec™ Restricted Security Area Surveillance (RSA Surveillance) plugin. For specific details about configuring your devices and software, refer to the OPTEX documentation.

1. Open the OPTEX Redscan Manager.
2. Click Settings > Detection mode.
3. Set the Detection area to either Horizontal or Vertical.
   You can’t use the Automatic option.
4. Click I/O Settings and do the following:
   1. Set Protocol to TCP.
   2. In the TCP settings section, set the following:

      IP Address (Destination)

      IP address of the server that hosts the RSA Surveillance plugin role.

      Port Number (Destination)

      Any port number that’s open and available. Remember it. You need this port number to configure the plugin role.

   3. Select the Heartbeat for device monitoring option.
   4. Click Save.
5. For OPTEX Redscan Mini lasers, do the following:
   1. From a web browser, log on to the laser's configuration web page using the laser's IP address and user credentials.
   2. Click Network Options, and then set the Web Server Protocol to HTTP & HTTPS or HTTPS.