Preparing OPTEX Redscan Pro lasers for integration with Security Center - To prepare your OPTEX Redscan Pro lasers for integration with Security Center, you must configure the OPTEX system to communicate with the Genetec™ Restricted Security Area Surveillance (RSA Surveillance) plugin. For specific details about configuring your devices and software, refer to the OPTEX documentation. - Restricted Security Area Surveillance - Plugin and extension guides - Integration guides

To prepare your OPTEX Redscan Pro lasers for integration with Security Center, you must configure the OPTEX system to communicate with the Genetec™ Restricted Security Area Surveillance (RSA Surveillance) plugin. For specific details about configuring your devices and software, refer to the OPTEX documentation.

1. From a web browser, log on to the OPTEX laser's configuration web page using the laser's IP address and user credentials.
2. Click Settings > Detection Range, and make sure that the Tilt direction is set to either Horizontal or Vertical.
   The value must not be set to automatic.
3. Click Security > HTTPS, and then set the Connection method to HTTP & HTTPS or HTTPS.
   NOTE: To learn how to create a certificate, see the manufacturer documentation.
4. Click Information > Installation information, and then set Latitude, Longitude, and Direction.
   The direction is the clockwise orientation angle from the north.