To prepare your Robin
devices for integration with Security Center, you must configure the Robin system to communicate with the Genetecâ„¢ Restricted Security
Area Surveillance (RSA Surveillance) plugin. For specific details about configuring your
devices and software, refer to the Robin
documentation.
Before you begin
- Make sure that your Robin system is operating as per the
manufacturer's specifications.
-
Make sure that your Robin devices and software are compatible with the RSA Surveillance plugin. For the latest compatibility
information, see Supported plugins in Security Center on the
Genetec TechDoc Hub.
Procedure
-
Deploy and configure the Robin system as described in the
Robin documentation.
-
Make sure that the radar device is configured in the Elvira system and is
operating as expected.
-
For some organizations, network security policies require that the
IP devices, routers, and switches in their network block unused ports. If your
organization has such policies in place, then make sure to open the TCP port that the
RSA Surveillance plugin and the Robin system use to communicate.
NOTE: The Elvira system uses port 16810 to communicate with the plugin.
-
Take note of the IP address of the Elvira system server.
You need this information to configure the radar device later.