Before you can monitor the restricted areas
secured by your SICK
laser system in Security Center, you must add each SICK
laser as a tracking system in Config Tool.
Procedure
-
From the Config Tool homepage,
open the Area view task.
-
Click Add an entity (), and then select
Tracking system.
The Add tracking system wizard opens.
-
On the Tracking system information page,
enter the following information:
- Type
- Select SICK.
- Name
- Enter a unique name for this tracking system.
-
On the
Communication page, enter the following
information:
- IP address
- The IP address of the laser.
-
Click Refresh connection status () to connect.
-
When the connection status turns
Online (), click
Next page ().
-
On the RSA configuration page,
enter the following information:
- Events
- Turn on the custom events that you want to monitor for this tracking system.
NOTE: You
can modify this later on the Properties page of the tracking
system.
-
Click Finish.
The SICK
laser is listed in the Area
view entity tree.
After you finish
Create RSA
zones.