Before you can monitor the restricted areas
secured by your Sensurity
perimeter intrusion detection system in Security Center, you must add each Sensurity
Universe Service as a tracking system in Config Tool.
Procedure
-
From the Config Tool homepage,
open the Area view task.
-
Click Add an entity (), and then select
Tracking system.
The Add tracking system wizard opens.
-
On the Tracking system information page,
enter the following information:
- Type
- Select Sensurity.
- Name
- Enter a unique name for this tracking system.
-
On the
Communication page, enter the following
information:
- IP address
- The IP address of the server that hosts the Sensurity Universe
Service.
- Port
- The TCP/IP port that the plugin and the Sensurity Universe Service
use to communicate.
- User and Password
- The login credentials for the tracking system.
-
Click Refresh connection status () to connect.
-
(Optional) Click Get config () to display the information about the Sensurity
Universe Service.
-
On the Specific configuration page, do the
following:
-
Click Add a sensor ().
Each sensor consists of a transmitter and a Receiver.
-
In the Transmitter list, select a device.
-
In the Receiver list, select a device.
-
In the Auto acknowledge alarm time field,
specify the amount of time RSA waits before acknowledging the
alarm.
-
On the RSA configuration page,
enter the following information:
- Import on map
- Select the map that you want to use to display the sensors in
Security Center.
- Events
- Turn on the custom events that you want to monitor for this tracking system.
NOTE: You
can modify this later on the Properties page of the tracking
system.
- Fence configuration
- Choose the color for the perimeter when its state changes. The
available options vary by system.
NOTE: The warning state is active
on the following events from Sensurity Universe Service:
- Environmental alarm
- Error alarm
- Tamper alarm
- Power alarm
- Change color on intrusion
- Enable this option to select the intrusion color. When the perimeter
device receives a zone alarm, the RSA Surveillance plugin can change the
color of the segment where the intrusion is detected.
-
- Intrusion
- The color of the perimeter segment when an intrusion is
detected.
-
Click Finish.
The
Sensurity
Universe Service and its devices are listed in the
Area view entity tree.
After you finish
Create RSA
zones.