To integrate an alarm receiver in Security Center, you must install the Genetec™ Receiver
extension on a Security Center expansion server and on all client
workstations.
What you should know
- Although it is possible to run the Receiver
extension on a server that hosts other Security Center roles, it is a best practice
to install the extension on a dedicated expansion server to ensure the
availability of Security Center.
- Install the extension on all of the Security Center client workstations.
Procedure
-
Open the GTAP Product Download page.
-
Under Download Finder, select the compatible version of
Security Center.
-
From the Genetec Plugins section, download the package for
your product.
-
Run the .exe file, and then unzip the file.
By default, the file is unzipped to
C:\Genetec.
-
Open the extracted folder, right-click the setup.exe file,
and click Run as administrator.
-
Follow the installation instructions.
-
On the Installation Wizard Completed page, click
Finish.
IMPORTANT: The Restart Genetec™ Server option
is selected by default. You can clear this option if you do not want to
restart the Genetec™ Server immediately. However, you must restart the
Genetec Server to complete the installation.
-
Close, and then open, any instances of Config Tool and Security Desk.
From the Intrusion Manager, click the
Extension
tab, and verify that the receiver is listed.