Adding a Southwest Microwave POE-S microwave system as a tracking system to Security Center - Restricted Security Area Surveillance 4.2

Restricted Security Area Surveillance Plugin Guide 4.2

Applies to
Restricted Security Area Surveillance 4.2
Last updated
2022-06-27
Content type
Guides > Plugin and extension guides
Language
English (United States)
Product
Restricted Security Area Surveillance
Version
4.2

Before you can monitor the restricted areas secured by your tracking system in Security Center, you must add each device as a tracking system entity in Config Tool.

Before you begin

Procedure

  1. From the Config Tool home page, open the Area view task.
  2. Click Add an entity (), and then select Tracking system.
    The Add tracking system wizard opens.
  3. On the Tracking system information page, enter the following information:
    Type
    Select Southwest Microwave.
    Name
    Enter a unique name for this tracking system.
    Model
    Select either Microwave POE Tx-Rx or Microwave POE Transceiver depending on the model you have.
  4. Add the processor modules in your perimeter:
    1. On the Specific configuration page in the Tracking system connection section, click Add processor module ().
    2. In the Add processor module dialog box, enter the following information:
      Name
      A unique name for this POE-S processor module.
      IP address
      The IP address of the processor module.
      Port
      The TCP port number that the processor module uses to send event notifications from sensors in the perimeter and to receive command and control information from the plugin.
      User and Password
      The administrator-level credentials used to connect remotely to the processor module.
    3. Click Refresh connection status () to connect.
    4. Click OK.
    5. Repeat the previous sub-steps for each processor module in your perimeter.
  5. For a Microwave POE Tx-Rx system, add the transmitter and receiver:
    1. In the Device mapping section, click Add a device ().
    2. From the Transmitter list, select Transmitter.
    3. From the Receiver list, select Receiver.
  6. On the RSA configuration page, enter the following information:
    Events
    Turn on the custom events you want to monitor for this tracking system.
    NOTE: You can modify this later on the Properties page of the tracking system.
    Fence configuration
    Choose the color for the perimeter when its state changes. The available options vary by system.

Results

The device is listed in the Area view entity tree.

After you finish

Create RSA zones.