Configuring a Robin Radar tracking system for integration with Security Center - Restricted Security Area Surveillance 4.2

Restricted Security Area Surveillance Plugin Guide 4.2

Applies to
Restricted Security Area Surveillance 4.2
Last updated
2022-06-27
Content type
Guides > Plugin and extension guides
Language
English (United States)
Product
Restricted Security Area Surveillance
Version
4.2

To prepare your Robin Radar system for integration with Security Center, you must configure specific settings.

Before you begin

  • Make sure your tracking devices and systems are operating as expected.
  • Make sure your devices and software are compatible with the plugin.

What you should know

This task describes in a general way how the Robin Radar system needs to be configured for it to communicate with the plugin. For specific details about the configuration of your devices and software, refer to your manufacturer's documentation.

Procedure

  1. Deploy and configure the Robin Radar system as described in the Robin Radar documentation.
  2. Make sure that the radar device is configured in the Elvira system and is operating as expected.
  3. If your organization's network security policies require that the IP devices, routers, and switches in your network block unused ports, then make sure to open the TCP port that the RSA Surveillance plugin and Elvira system server use to communicate.
    NOTE: The Elvira system uses port 16810 to communicate with the plugin.
  4. Take note of the IP address of the Elvira system server.
    You will need this information to configure the radar device later.