Configuring an Avon tracking system for integration with Security Center - Restricted Security Area Surveillance 4.2

Restricted Security Area Surveillance Plugin Guide 4.2

Applies to
Restricted Security Area Surveillance 4.2
Last updated
Content type
Guides > Plugin and extension guides
English (United States)
Restricted Security Area Surveillance

To prepare your Avon radar system for integration with Security Center, you must make sure that specific settings are configured.

Before you begin

  • Make sure your tracking devices and systems are operating as expected.
  • Make sure your devices and software are compatible with the plugin.

What you should know

This task describes in a general way how Avon radar devices need to be configured to communicate with the plugin. For specific details about the configuration of your devices and software, refer to your manufacturer's documentation.


  1. Deploy and configure the radar device as documented in the manufacturer documentation.
  2. Make sure that the device is operating as expected.
  3. If your organization's network security policies require the IP devices, routers, and switches in your network to block unused ports, then make sure to open the UDP port that the RSA Surveillance plugin and Avon devices use to communicate.
    NOTE: Avon device ports used to communicate with Security Center can be found in the configuration of the radar.
  4. Take note of the following information, which you will need later to configure the Avon device:
    • Multicast IP used by the Avon device
    • Port used by the Avon device