To receive information from the Schindler PORT elevator system
in Security Center, you must enable communication
between the two systems.
Procedure
-
From the Config Tool home page, open the
Plugins task.
-
Select the elevator system from the entity browser, and click the
Properties tab.
-
In the Interfaces section, configure the
following:
- Database
- The IP address and port number of the Schindler PORT database interface. This information is
required to push Security Center cardholder
information into the Schindler PORT
system.
- Primary call
- The IP address and port number of the Schindler PORT
call interface that receives elevator requests from Security Center. This information is required to
dispatch elevators. If necessary, a secondary call address can also be added.
- Reporting
- The IP address and port number of the Schindler PORT reporting interface that Security Center uses to receive
the information used to generate reports.
-
(Optional) To enable Synergis readers
for use with Schindler PORT zones and terminals, switch the
Synergis integration option to
ON.
-
Click Apply.
Results
The elevators from the
Schindler PORT elevator system are added
to the entity browser.