Adding a Sharp camera to the ALPR Manager - Security Center 5.10

To send ALPR data from the camera to Security Center, you must add the camera to an ALPR Manager.

To manually add a camera running SharpOS 12.7 or later:

1. From the Config Tool home page, click the ALPR task and select Roles and units.
2. Select the ALPR Manager role from the drop-down list.
3. Click ALPR unit.
   The Creating a unit dialog box opens.
4. Enter a Name for the camera.
5. Enter the camera's IPv4 IP address.
   NOTE: If the camera is behind a NAT, enter the IP address of the NAT, and the port of the NAT which has been associated to port 443 of the camera.
6. This SharpOS version requires HTTPS communication. Enter Port 443.
   NOTE: If the camera is behind a NAT, enter the IP address of the NAT, and the port of the NAT which has been associated to port 443 of the camera.
7. From the Location list, assign the camera to an area entity.
   
8. Click Next.
9. Enter the Username and Password used to log onto the Sharp Portal and click Next.
10. Review the settings and click Create.

To manually add a camera running SharpOS 12.6 or earlier:

1. From the Config Tool home page, click the ALPR task and select Roles and units.
2. Select the ALPR Manager role from the drop-down list.
3. Click ALPR unit.
   The Creating a unit dialog box opens.
4. Enter a Name for the camera.
5. Enter the Sharp unit's IPv4 IP address.
6. Enter Port 443 for HTTPS or 80 for HTTP, according to the Sharp unit's configuration.
7. From the Location list, assign the camera to an area entity.
   
8. Click Next.
9. Enter the camera's Control port (default: 8001).
   This information should match what is displayed in the Sharp Portal configuration page.
   
10. Click Next.
11. Review the settings and click Create.
    IMPORTANT: When using the LPM protocol, the Extension in the Sharp Portal is automatically set to None. Do not change the extension.