Adding a SharpV camera to the Archiver - Security Center 5.10

To store the ALPR images that are associated with the reads and hits, you must add the Sharp camera to the Archiver.

1. Open the Video task, and select the Archiver role to configure.
2. Click Add an entity > Video unit.
   The Manual add dialog box opens.
3. If you have multiple Archiver roles, select one to manage the unit from the Archiver drop-down list.
4. From the Manufacturers drop-down list, select AutoVu™.
5. From the Product type drop-down list, select All.
6. Enter the IP address of the video unit.
   • Select IPv4 or IPv6 and enter the IP address.
   • If your network supports DHCP, enter the assigned IP address.
     NOTE: If this address is subject to change, click Hostname to enter the hostname of the unit.
   To add multiple units in a single operation, enter a range () of IP addresses .
7. Enter the HTTP port for the unit (default = 80).
   NOTE: If the unit uses HTTPS, enter the HTTP port (80) here. You will enter the HTTPS port in the following steps.
8. Select the Authentication method for the camera.

   Default logon

   The camera uses the default logon defined for the Archiver in the Extensions tab. Using this method, you can define the same logon credentials for multiple cameras.

   IMPORTANT: You cannot use the default logon when adding a SharpV camera. You must use the credentials you configured when you first logged on to the SharpV portal.

   Specific

   Enter the logon credentials for the camera. Turn on Use HTTPS if you have applied a certificate.

   NOTE: Sharp cameras running SharpOS 12.7 or later must use HTTPS communication.

9. From the Location drop-down, assign the camera to an area entity.
10. Click Add.
    
    The notification tray displays the message "Adding unit started". If successful, it displays the message "Unit added successfully".