ALPR unit - Properties tab - Security Center 5.11

In the Properties tab, you can view hardware and software information about the SharpV unit, such as the IP address and port being used. You can also associate a specific hotlist to the SharpV, or link the ALPR camera in the SharpV to an Omnicast™ camera, or the SharpV unit's own context camera.

Properties

Displays hardware and software information about the Sharp unit:

IP address

IP address of the SharpV unit.

Port

Port used by the ALPR Manager to communicate with the SharpV unit.

Version

AutoVu PlateReaderServer software version running on the unit.

Type

Unit hardware version.

Serial number

Unit factory installed serial number.

Updater Service version

Displays the Updater service version running on the Sharp.

Firmware version

Displays the firmware version running on the Sharp.

Network configuration (SharpV units only)

IP address

The IP address of the SharpV unit. The ALPR Manager searches for the SharpV unit at this IP address.

Assignment

How the SharpV unit was enrolled in Security Center:

Passive

The ALPR Manager discovered the Sharp unit on the network using the discovery port.

Active

The SharpV unit was added manually in Security Center Config Tool.

Port

Port used by the ALPR Manager to communicate with the fixed Sharp unit.

Devices

Link the ALPR camera to an Omnicast™ camera.

File association

Select how the SharpV unit behaves with hotlists:

Inherit from ALPR Manager role

The SharpV unit uses the hotlists associated with its parent ALPR Manager. This is the default setting.

Specific

Associate specific hotlists with the SharpV unit. This allows you to create Event-to-actions in Security Desk that trigger on that specific hotlist. For example, if you’re using the SharpV to allow access to a parking lot, you would put the vehicle plates on a hotlist, and then associate that hotlist to the SharpV.