Adding access control unit extensions - Security Center 5.11

Security Center Administrator Guide 5.11

Applies to
Security Center 5.11
Last updated
2023-11-10
Content type
Guides > Administrator guides
Language
English
Product
Security Center
Version
5.11

For the Access Manager to communicate with access control units, you must add the manufacturer-specific extensions.

What you should know

Extensions are added by default when the Access Manager is created. However, the Genetec™ Synergis™ extension required by Synergis units is created with the default discovery port, 2000. If you configured your Synergis units with a different port number, you must also change or add it to the Access Manager.
Best Practice: If you have two or more Access Manager roles controlling Synergis units on the same subnet, make sure that they use different discovery ports. Otherwise, you might experience performance issues with your Synergis units.

Procedure

  1. Open the Access control task, and click the Roles and units view.
  2. Select the Access Manager, and click the Extensions tab.
  3. At the bottom of the extensions list, click Add an item ().
  4. In the Add extensions dialog box, select the extension types you need and click Add.
    NOTE: If you only selected HID VertX, the procedure ends here.
  5. Select the Genetec Synergis extension you added.
  6. To add a discovery port, click Add an item (), at the bottom of the Discovery ports section.
  7. In the Discovery port dialog box, enter the port number configured for your Synergis units and click Create.
    The port number must match the discovery port configured on your Synergis units. The default value is 2000.
  8. Click Apply.