Preparing to deploy a mobile SharpZ3 system - Security Center 5.11

Security Center Administrator Guide 5.11

Product
Security Center
Content type
Guides > Administrator guides
Version
5.11
Language
English
Last updated
2024-07-05

To make sure that your mobile AutoVu™ deployment goes smoothly, you must perform a series of pre-configuration steps.

The following steps describe a typical AutoVu deployment. Depending on your specific installation requirements, your process might be different.
NOTE: Settings that are pre-configured during your installation are not listed in this task. For example, when you install Security Center, the ALPR Manager root folder is automatically created on your computer at the location C:\Genetec\AutoVu\RootFolder.
Security Center
Step Task Where to find more information

1

Install Security Center Server software on your main server.

2

(Optional) Install Security Center Server software on expansion servers.

3

(Optional) Add an additional server to act as secondary server for the ALPR Manager to set up failover.

4

Install Security Center Client software on at least one workstation.

SharpZ3 hardware
Step Task Where to find more information

1

Install the SharpZ3 camera system on the patrol vehicle.

2

Update the SharpZ3 system to the latest SharpOS version.

3

Configure the SharpZ3 system in the Sharp Portal.

Genetec Patroller
Step Task Where to find more information

1

Install Patroller on the in-vehicle computer.

2

Upgrade Patroller to the latest software version.

After you finish

Configure the additional settings for your AutoVu mobile installation type: