Creating permit restrictions - Security Center 5.12

Security Center Administrator Guide 5.12
Product
Security Center
Content type
Guides > Administrator guides
Version
5.12
Language
English
Last updated
2024-09-13

You can add a permit restriction entity in Security Center Config Tool to apply restrictions to a permit. After you create the entity, you’ll configure its settings for your enforcement scenario.

Before you begin

Create the permit and configure the permit.

What you should know

  • In University Parking Enforcement, to create an enforcement rule, you need to apply restrictions to the permits you add. Genetec Patroller™ downloads permit restrictions when it connects to Security Center.
  • Ideally, a permit restriction should only contain the permits that are relevant to the restriction, that is, it is best practice not to add all of your permits to every permit restriction.
    NOTE: There is no limit to the number of permits that can be added to a permit restriction, but if you put all the permits in all permits restriction, you might notice a delay before the Patroller hit pop-up is displayed. In this case, you can configure the system to only search permits from the zone currently being scanned by the patrol vehicle. For more information, see [KBA-79138] Patroller hit detection delay in University mode.
  • You can apply permit restrictions to AutoVu™ Free-Flow parking rules.
  • For Genetec™ Mobile users, permit restrictions are displayed as Zones in the application.

Procedure

  1. From the Config Tool homepage, click ALPR > Permits restrictions, and then click Permit restriction ().
    A new permit restriction entity is added in the list of all the permit restrictions on your system.
  2. In the Identity tab, enter the required information:
    Name
    In City Parking Enforcement, this name appears in Genetec Patroller™ on the overtime rule selection page. In University Parking Enforcement, this name appears appended to the parking lot name on the zone selection page.
    Tip: Choose a name that describes the details of the enforcement scenario. This makes it easier to select it in Patroller when you have more than one available.
    (Optional) Description
    You can add a longer description for the rule. This field does not appear in Patroller.
    (Optional) Logical ID
    Enter a Logical ID if applicable.
  3. Click Apply.

After you finish

Configure the permit restrictions.