Installing Security Center Server for NEC Cluster - Security Center 5.10

Security Center Installation and Upgrade Guide for NEC Cluster 5.10

series
Security Center 5.10
revised_modified
2021-03-05
category_custom
Guides
Guides > Installation guides
prodname_custom
Security Center unified platform > Security Center
vrm_version
5.10

After the NEC ExpressCluster software has been installed, you must install Security Center Server and SQL Server on your active server first, and then on your standby server.

Before you begin

A Security Center license will be needed for each main server.

Procedure

  1. Install Security Center Server including the appropriate Omnicast™ compatibility pack, if necessary, and SQL Server. For more information, see the Security Center Installation and Upgrade Guide.
  2. Launch the Server Admin application and do the following:
    1. If the server is a Security Center main server (hosting the Directory role), apply the Security Center license in the Server Admin.
      NOTE: Two Security Center server licenses are needed; one for each server.
    2. In the Server Admin, make sure that the network card binding for the Genetec Server is set to Any.
    3. Close the Server Admin and reboot the server.
  3. Repeat the steps on the standby server.
  4. Using your Config Tool application, log on to the active Security Center server to ensure that the roles you need have been successfully created.
  5. Install Security Center (see the Security Center Installation Guide).