Monitoring ALPR events in map mode - Security Center 5.11

You can use map mode in the Monitoring task to view all the ALPR events on a map.

What you should know

In map mode, the canvas displays a road map. The map opens centered on the location you zoomed in to, the last time you switched to map mode. You can use your mouse to pan or zoom on the map.

NOTE: The map mode can only be used to display static ALPR events. To show Genetec Patroller™ positions on a map, use the Patrol vehicle tracking task. To work with a general purpose map, display a map () in a tile, or use the Maps task.

The following symbols represent each ALPR event type on the map:

Circle

Reads and hotlist hits.

Triangle

Permit reads and hits.

Diamond

Overtime reads and hits.

You can change the default colors of ALPR events from hotlist, overtime rule, and permit restriction in Config Tool.

1. In the Monitoring task, click Switch to map mode ().

   

2. To find an event on the map, double-click the event in the event list.
   The event location is displayed on the map and the event is circled.
3. To view information about the event, click the event on the map.

   

   The Properties window opens. The event properties and commands shown in the Properties window are similar those available in tile mode.

4. To keep the Properties window open, click Push pin ().