Before you can search for video analytics events that were recorded on Bosch units using the Forensic search report, the units must be configured to record video locally, and the Bosch Video SDK must be installed on Security Desk workstations.
What you should know
Install the Bosch video units on the network.
The Bosch devices must support intelligent video analytics (IVA).
- On the unit web page, configure the unit to record locally on the device or on an iSCSCI network drive.
On the unit web page, configure the Bosch IVA settings.
NOTE: Bosch video units that support IVA record video images and raw, unprocessed metadata. This means that the analytic configuration can be changed at any time and used for historical searches. For example, if you initially configure your analytics for the event “line crossed” and you later decide to change the analytic configuration for the event “loitering”, you can still search for the new analytic event.
Install the Bosch Video SDK on all Security
Desk workstations that use the Forensic search task.
You can download the Bosch Video SDK installation package at http://ipp.boschsecurity.com/en/.
Add your Bosch
video units (IP cameras or video encoders) in Security Center.
The Archiver must be connected to the device to send command and control signals to the video unit. However, since the unit records by itself, the Archiver only provides duplicate video recordings, and a perhaps a longer retention period for the archives. You can only search for video analytic events on video recordings that are stored on the camera.