Configuring Axis P7701 units - Security Center

Security Center Video Unit Configuration Guide

Applies to
Security Center
Last updated
Content type
Guides > User guides
Security Center
User guides

Before adding Axis P7701 units to Security Center, you must complete some pre-configuration steps.


  1. Open the unit's web page.
  2. Click Video & Audio > General Setup.
  3. Depending on the video output mode required, do one of the following:
    • If composite output mode is required, select Composite from the Video output option.
      NOTE: NTSC and PAL will be the only Analog format options available in Config Tool.
    • If VGA and DVI output mode is required, do the following:
      1. From the Video output drop-down list, select VGA and DVI.
      2. From the TV system drop-down list, select the required analog format.
        NOTE: NTSC and PAL will be disabled as Analog format options in Config Tool.
  4. Click Save.

After you finish

If the unit is already added in Security Center, then restart the unit.