Configuring the Evervision IPE3510 and IPE4100 - Security Center

Security Center Video Unit Configuration Guide

Applies to
Security Center
Last updated
Content type
Guides > User guides
English (United States)
Security Center

You can configure both the IPE3510 and IPE4100 to multicast and multistream.


  1. Open the unit's web page.
  2. Click Video & Audio > Codec.
  3. Select Enable streaming for both First and Second Stream.
    NOTE: You can multicast only when you set the codec to MJPEG; it is not supported with H.264 codecs.
  4. Select the desired codec, resolution, and frames per second (FPS).
  5. Click Apply.
  6. Add the unit to Security Center.
    If your unit was already part of the Security Center system, restart the unit for your changes to take effect.