To control an associated PTZ camera with a Panasonic WJ-GXE100 or WJ-GXE500 unit, you must configure the serial port on the unit’s web page.
What you should know
IMPORTANT: For PTZ commands to be sent to a WJ-GXE500 unit, the unit must be restarted from Config Tool after it is added in Security Center.
- Open the unit's web page.
- Click RS485 tab. , and then click the
- Beside RS485 transmission, select On.
Complete the rest of the information.
The options entered should match was set on the associated PTZ camera.
- Click Set.