You can configure Axis cameras to use the AXIS Video Motion Detection (VMD) ACAP (Axis
Camera Application Platform) application for on-unit motion detection. AXIS VMD is easier to
configure and more reliable than the legacy unit motion detection software.
Before you begin
AXIS VMD ACAP application comes pre-installed with firmware version 5.80 or later. For
earlier firmware versions, you must install the VMD application through the unit's web
page.
Procedure
-
Add the camera to Security Center.
If your unit is already part of the Security Center system, restart the unit for your changes
to take effect.
-
Select the camera you are configuring from the Video task in
Config
Tool.
-
Click the Motion detection tab.
-
Turn on the Motion Detection option and switch
Detection is done on to Unit.
-
Select Use camera application motion detection to use the AXIS
VMD ACAP.
-
Configure the following motion detection settings:
By default, the setting values that were configured on the unit are used. These
settings will only appear if
Configure motion detection on unit is disabled.
- Ignore short-lived objects
- Select this option to ignore objects that only appear in the video image for a
short period of time, such as lights from a passing car. Specify the number of
seconds that the object must be in the video image for motion to be detected.
- Ignore swaying objects
- Select this option to ignore objects that only move a short distance in the video
image, such as moving tree branches or flags. Specify the percentage of the width
and height of the image in which there must be movement, for motion to be
detected.
- Ignore small objects
- Select this option to ignore small objects in the video image. Specify the
percentage of the width and height of the image that an object must take up for
motion to be detected.
- Configure the motion zones from the Config
Tool
- Select this option to configure the motion zones from Config
Tool instead of using the motion zones
that were configured on the unit.
NOTE: The
motion zone configuration on the unit can only be used if the zone is rectangular.
Otherwise, the motion zone must be configured from Config
Tool.
-
Under Motion on and Motion off, click
Event to select the event to be triggered in each case.
-
Click Apply.