Configuring edge recording for Sony 5th generation units - Security Center 5.11.0.0

Security Center Video Unit Configuration Guide 5.11.0.0

Product
Security Center
Content type
Guides > User guides
Version
5.11
Release
5.11.0.0
Language
English
Last updated
2022-04-19

Archive transfer is supported on Sony units with firmware 1.61 and later in Security Center through the Sony Edge Storage (edge recording) feature. To use edge recording and archive transfer with Sony 5th generation cameras, you need to enable the Edge Storage, and configure some additional settings on the unit’s web page.

Procedure

  1. Open the unit's web page.
  2. Click Setup > Edge Storage.
  3. In the Edge Storage option, click On, and then click OK.
    NOTE: If you set the Effective period option to Always, edge recording is stopped if you change the video stream type.
  4. Click the Image memory tab, and then click the Common tab.
  5. In the Image memory option, click Off, and then click OK.
  6. Click the Alarm recording tab.
  7. In the Alarm recording option, click Off, and then click OK.
  8. Click the Periodical recording tab.
  9. In the Periodical recording option, click Off, and then click OK.
  10. Click the FTP client tab, and then click the Common tab.
  11. In the FTP client option, click Off, and then click OK.
  12. Click the Alarm sending tab.
  13. In the Alarm sending option, click Off, and then click OK.
  14. Click the Periodical sending tab.
  15. In the Periodical sending option, click Off, and then click OK.
  16. Click the e-Mail (SMTP) tab, and then click the Alarm sending tab.
  17. In the Alarm sending option, click On.
  18. In the File attachment option, click Off, and then click OK.
  19. Click the Periodical sending tab.
  20. In the Periodical sending option, click Off, and then click OK.
  21. Click the System tab, and then click the Installation tab.
  22. In the Video out option, click Off, and then click OK.