Configuring FLIR PT-602CZ units - Security Center 5.11.3.0

Security Center Video Unit Configuration Guide 5.11.3.0

Product
Security Center
Content type
Guides > User guides
Version
5.11
Release
5.11.3.0
ft:locale
en-US
Last updated
2024-03-28

The way FLIR PT-602CZ units are added to Security Center depends on which codec you are using. If you want to use the MPEG-4 or MJPEG codec on the unit, there are some additional configuration steps to perform on the unit's web page before adding the unit to Security Center.

Procedure

To add a FLIR PT-602CZ unit for use with the H.264 codec:

  1. From the Config Tool homepage, open the Video task.
  2. Select the Archiver to manage the unit.
  3. Click Add an entity () > Video unit .
    The Add unit dialog box opens.
  4. From the Manufacturer list, select ONVIF.
  5. From the Product type list, select All.
  6. Complete all other settings as needed, and click Add.

To add a FLIR PT-602CZ unit for use with the MPEG-4 or MJPEG codec:

  1. Open the unit's web page and click Maintenance > Server > Server status.
  2. Under Server Status click Stop.
  3. After the server stops, click Sensor > Video, then click the VIDEO 0 tab.
  4. Scroll down to the Settings section and select either MPEG4 or MJPEG as the codec.
  5. Click the VIDEO 2 tab and repeat step d above.
  6. From the Config Tool homepage, open the Video task.
  7. Select the Archiver to manage the unit.
  8. Click Add an entity () > Video unit .
    The Add unit dialog box opens.
  9. From the Manufacturer list select ONVIF.
  10. From the Product type list, select Basic.
  11. Complete all other settings as needed, and click Add.