To stream from a camera plugged in the SRM-872, you need to configure the camera's
credentials with Smartviewer AUTO.
Before you begin
- Use a camera that is ONVIF Profile S compliant or a Hanwha Techwin unit that
supports SUNAPI.
- Restore the unit to factory defaults, including the network. The SRM-872 assigns an
IP address to the unit.
- Ensure audio in or out is active for all the profiles present on the unit. Perform
an audio in or out test using the unit's web page. The codec needs to be G711.
Procedure
-
Connect to a
device.
-
Plug camera to NVR if not already done.
-
Click Device and click Camera.
You can see the IP in the Setting column of the port into which you
plugged it. The device is PoE, so no external power is required.
-
Click the IP address of the camera that you want to configure.
-
In the Protocol field, select SUNAPI or ONVIF.
-
Select the Authentication checkbox.
-
Enter the username and password for the camera.
-
Click Connect.
-
Click OK.
After you finish
If the IP does not appear, you might need to reboot the SRM. Leave the cameras
connected.