Additional steps required for integrating i-PRO units - Security Center 5.12.2.0

The following additional configuration steps are required for some of your units to work in Security Center.

MJPEG multi-streaming

Multi-streaming in MJPEG is supported on certain I-PRO cameras in Security Center. In the Video tab of I-PRO camera entities in Config Tool, the Quality setting must be the same for both video streams, and can only be configured from stream 1.

Edge analytics for i-PRO WJ-NT314 encoders

To use edge analytics with i-PRO WJ-NT314 encoders, it must be configured for each active channel using the unit’s web page.

I/O pin configuration

The following units do not have a hardwired pin configuration:

• DG-NS202
• WV-NS954
• WV-NW964
• WV-NP502
• WV-SP508
• WV-NW502S
• DG-NW502S

The input and output pins cannot be configured through the web page for these units, and other S-series and X-series units. This is because Security Center enforces the configuration in the table below.

NOTE: i-PRO pin types other than input/output, such as auxiliary pins, are not supported in Security Center.