Configuring FLIR PT-602CZ units - Security Center 5.12.2.0

The way FLIR PT-602CZ units are added to Security Center depends on which codec you are using. If you want to use the MPEG-4 or MJPEG codec on the unit, there are some additional configuration steps to perform on the unit's web page before adding the unit to Security Center.

To add a FLIR PT-602CZ unit for use with the H.264 codec:

1. From the Config Tool homepage, open the Video task.
2. Select the Archiver to manage the unit.
3. Click Add an entity () > Video unit .
4. In the Add unit dialog box, apply the following settings:
   1. From the Manufacturer list, select ONVIF.
   2. From the Product type list, select All.
   3. Complete all other settings as needed, and click Add.

To add a FLIR PT-602CZ unit for use with the MPEG-4 or MJPEG codec:

1. Open the unit's web page and click Maintenance > Server > Server status.
2. Under Server Status click Stop.
3. After the server stops, click Sensor > Video, then click the VIDEO 0 tab.
4. Scroll down to the Settings section and select either MPEG4 or MJPEG as the codec.
5. Click the VIDEO 2 tab and repeat the previous step.
6. From the Config Tool homepage, open the Video task.
7. Select the Archiver to manage the unit.
8. Click Add an entity () > Video unit .
9. In the Add unit dialog box, apply the following settings:
   1. From the Manufacturer list, select ONVIF.
   2. From the Product type list, select Basic.
   3. Complete all other settings as needed, and click Add.