Configuring UDP units - Security Center 5.12.2.0

Before adding UDP units in Security Center, you must complete some pre-configuration steps.

1. Open the unit's web page.
2. Click the Basic Configuration tab, and then click Web Server.
3. Under HTTP(S) Settings, select the HTTP option and click Apply.
   IMPORTANT: If this option is not enabled, automatic unit discovery does not work in Security Center.
4. Click the Video & Audio tab, and select Codec.
5. Under Video Stream Codec Settings, click the First Stream tab and select H.264 from the Video Codec list, then click Apply.
6. Click the Second Stream tab, and select MPEG4 from the Video Codec list, then click Apply.
7. Click the System Options tab, and select RTSP/RTP.
8. Select the Does not include NAL unit header option.
9. Click the UNICAST tab, and select Enable RTP Session.
10. Under RTP Configuration-first stream, make sure the Session name parameter displays firststream.
11. Under RTP Configuration-second stream, make sure the Session name parameter displays secondstream.
12. Click Apply.