If there are analog cameras connected to the Bosch Divar 700, you must enable the video
input for those units in the Divar’s web page.
Before you begin
Connect the video output of the analog cameras to the Video In connections on the Divar
unit. The number of connectors depends on the type of Divar you have. The maximum number of
analog cameras you can have is 16.
Procedure
-
Open the Bosch Divar 700’s web page.
-
Open the Configuration menu.
For details on how to access the Configuration menu, see your
Bosch documentation.
-
Click .
-
Click the numbered tab corresponding to the Divar Video In connector, that an analog
camera is connected to.
-
In the General tab, select Enable video
input.
-
To enable PTZ on the camera, click the Control tab, and select
the Enable PTZ option.
-
Select a Protocol from the drop-down list.
-
Select a Device address.
Make the address the same as the Divar camera input.
-
Repeat the steps for each analog camera connected to the Divar unit.
-
Click .
-
If the cameras are already added in the Security Center system, restart the Divar unit for the
cameras to become visible in Security Center.