To configure your Arecont units to support downscaling in Config Tool, you must first enable downscaling and
then select a scaling size.
What you should know
- Flexible cropping is enabled by default for Arecont cameras but it is not supported
in Security Center. As a result, the image
size may be altered by a few columns.
Procedure
-
From the Video task in Config Tool, select the camera to
configure.
-
Click the Video tab, and set Down
scaling to On.
-
Click the Hardware tab and from the Scaling
size list, select a resolution.
NOTE:
- If the selected Scaling size on the
Hardware tab has a different aspect ratio than the
Resolution selected on the
Video tab, the camera automatically crops the
image to the closest supported Scaling size for the
selected resolution.
- If Half resolution was selected in the
Video tab, the image will be half the size of the
Scaling size.
-
Click Apply.