If there are network cameras connected to the Bosch Divar 700, you must configure those
units on the Divar 700’s web page.
What you should know
The maximum number of network cameras you can have is 32. If you have analog cameras,
connect them to the Divar Video In connectors. Start at connector 1 and use the remaining
connectors for the network cameras. For example, if connectors 1 - 7 are analog cameras,
connectors 8 - 32 could be network cameras.
Procedure
-
Open the Bosch Divar 700’s web page.
-
Click .
-
Click the numbered tab corresponding to the Divar Video In connector for a network
camera.
-
In the General tab, select Enable video
input.
-
Do one of the following:
- Click the Manual setup button, and type the IP
address, Input, Stream, and
Password information of the camera.
- Click the Auto detect button if the feature is available
for that camera.
-
To enable PTZ on the camera, click the Control tab, and select
the Enable PTZ option.
-
Select a Protocol from the drop-down list.
-
Select a unique Device address.
Tip: Use the same number as the input that the camera is connected to.
-
Repeat the steps for each network camera connected to the Divar unit.
-
Click .
-
If the cameras are already added in the Security Center system, restart the Divar unit for the
cameras to become visible in Security Center.