Configuring the Bosch Intuikey CCTV keyboard - You must configure the Bosch Intuikey CCTV keyboard before using it in Security Desk. - Security Center 5.12.2.0 - User guides

Security Center Video Unit Configuration Guide 5.12.2.0
Product
Security Center
Content type
Guides > User guides
Version
5.12
Release
5.12.2.0
ft:locale
en-US
Last updated
2025-04-29

You must configure the Bosch Intuikey CCTV keyboard before using it in Security Desk.

Before you begin

Make sure that the RS-232 port of the Bosch Intuikey CCTV keyboard is connected to the COM port of the computer.

What you should know

The top four buttons on Bosch Intuikey CCTV keyboards can control the Play, Pause, Next, and Previous commands of a camera sequence in the Security Desk. The default button association is the following:
Button on Bosch keyboard Command in Security Desk
Pause Pause
Play Play/Resume
FF Show previous camera in the sequence
REW Show previous camera in the sequence

Procedure

  1. From the Security Desk homepage, click Options > Peripherals > Keyboard.
  2. From the Keyboard protocol list, select Bosch Intuikey.
  3. From the Communication port list, select the COM port you just connected the keyboard to.
  4. From the Data bits list, select 8.
  5. From the Parity list, select None.
  6. From the Stop bits list, select One.
  7. From the Baud rate list, select 19200.
  8. Click Connect > Save .

Results

The keyboard is ready to use.