To use multicast streaming with MOBOTIX units in Security Center, you must enable multicast on the camera for at least one stream.
- From the Video task in Config Tool, select the camera to configure, and then click the Video tab.
- In the Network settings section, set the Connection type option to Multicast.
- Set the Multicast address and port number.
- Click Apply.
- Open the unit web page.
- Click .
- In the General Settings section, set the Multicast interface values as they were configured in Config Tool.
- For the MxPEG Stream 1, select the Enable Multicast option, and then enter the multicast IP address and port number.