Configuring network cameras connected to Bosch Divar 700 DVRs - Security Center 5.7 SR2

Security Center Video Unit Configuration Guide 5.7 SR2

series
Security Center 5.7 SR2
revised_modified
2018-04-04
category_custom
Guides
Guides > User guides
prodname_custom
Security Center unified platform > Security Center
vrm_version
5.7

If there are network cameras connected to the Bosch Divar 700, you must configure those units in the Divar’s web page.

What you should know

The maximum number of network cameras you can have is 32. If you have analog cameras, connect them to the Divar Video In connectors starting at connector 1, and use the remaining connectors for the network cameras (for example, if connectors 1-7 are analog cameras, connectors 8-32 could be network cameras).

Procedure

  1. Open the Bosch Divar 700’s web page.
  2. Click Configuration > Video & Audio.
  3. Click the numbered tab corresponding to the Divar Video In connector for a network camera.
  4. In the General tab, select the Enable video input option.
  5. Do one of the following:
    • Click the [Manual setup] button, and type the IP address, Input, Stream, and Password information of the camera.
    • Click the [Auto detect] button if the feature is available for that camera.
  6. To enable PTZ on the camera, click the Control tab, and select the Enable PTZ option.
  7. Select a Protocol from the drop-down list.
  8. Select a Device address.
    The address must be unique. It is recommended to use the same number as the input the camera is connected to.
  9. Repeat the steps for each network camera connected to the Divar.
  10. Click Save > Close.
  11. If the cameras are already added in Security Center system, restart the Divar unit for the cameras to become visible in Security Center.