Configuring Epiphan VGA Broadcaster units - Security Center 5.7 SR5

Security Center Video Unit Configuration Guide 5.7 SR5

Applies to
Security Center 5.7 SR5
Last updated
2019-02-15
Content type
Guides
Guides > User guides
Language
English
Product
Security Center
Version
5.7

You must configure an Epiphan VGA Broadcaster unit on the unit's web page before you add it to Security Center.

Procedure

To configure an Epiphan VGA Broadcaster Lite unit:

  1. Click Unit > Unit's Web page and log on.
  2. Click Configuration > Stream Setup.
  3. From the Stream type drop-down list, select RTSP (H.264 codec).
  4. Under RTP/UDP stream, do the following:
    1. Make sure that the Enable RTP/UDP stream option is cleared.
    2. To prevent tearing during playback, select Enhanced compatibility mode.
  5. Configure any other video settings as necessary.
  6. For motion detection to work properly, set a high Bitrate value according to the resolution and frame rate you selected.
  7. Click Apply.

To configure an Epiphan VGA Broadcaster unit (firmware 2.4.0 and later):

  1. Click Unit > Unit's Web page and log on.
  2. Click Configuration > Stream Setup.
  3. From the Codec drop-down list, select H.264.
  4. To prevent tearing during playback, select Enhanced compatibility mode (h.264 slicing for RTP).
  5. Configure any other video settings as necessary.
  6. For motion detection to work properly, set a high Bitrate value according to the resolution and frame rate you selected.
  7. Click Apply.