Notes about adding Honeywell encoders - Security Center 5.7 SR5

Security Center Video Unit Configuration Guide 5.7 SR5

Applies to
Security Center 5.7 SR5
Last updated
2019-02-15
Content type
Guides
Guides > User guides
Language
English
Product
Security Center
Version
5.7

The following steps are required before adding Honeywell NVE-1008 and ENC-8M2 encoders to Security Center.

NVE-1008
When adding the NVE-1008 unit to Security Center, use the IP address of the unit.

On the unit's web page, change the RTP payload type from 104 to another ID, to enable the 2nd stream.

ENC-8M2
In Config tool, set the IP address to the multicast address on the unit and set the UDP port to 60000.

Configure the encoders to match the camera setting on the unit’s web page. For example, if the camera is set to NTSC you must configure the encoders to NTSC.

On the unit's web page, set GOP mode to I or IP and the Frame rate reduction to None.