Adding Interlogix VisioWave units - Security Center

Security Center Video Unit Configuration Guide

Applies to
Security Center
Last updated
Content type
Guides > User guides
Security Center

Before you can add Interlogix VisioWave units in Security Center, you must add the unit using the Central Configuration Server.


  1. Open the Central Configuration Server in Internet Explorer.
  2. Click Equipment > New Video Equipment.
  3. In the Equipment name field, type a name for the unit.
  4. In the IP Address field, type the IP address of the unit.
  5. From the Product Hardware Range drop-down list, select the unit type (for example, EVOLUTION HD or DISCOVERY 300).
    NOTE: The number of inputs available depends on the unit type.
  6. Click Next until the Serial Ports page.
  7. In the Serial Ports, enter the following information:
    1. Type a name for the first serial port.
    2. From the Port drop-down list, select COM1.
    3. Type RS485 HALF DUPLEX.
  8. Click Next > Next > OK.
  9. Click Apply in the top-right corner of the Central Configuration Server window.
    When your changes are applied, a confirmation appears in the window.
  10. Click OK.