Configuring ATEME VSS-441-R4TE units - Security Center 5.8.2.0

Before adding ATEME VSS-441-R4TE units to Security Center, you must configure the video inputs, enable all video streams, and configure the serial port on the unit’s web page.

1. Open the unit's web page.
2. Click Video setting > Physical Input.
3. On the Physical Video Input Settings page, click the Video 1 input tab.
4. From the Color System drop-down list, select NTSC.
5. From the Scan Mode drop-down list, select Progressive.
   
6. Repeat the steps for every video input.
7. Click Save.
8. Click Streaming > Video Stream Settings.
9. On the Video Streams Settings page, click the Video 1 input tab, and then click the Stream 1 tab.
10. Select the Enable stream option.
    
11. Repeat steps 9 and 10 for every video input and every video input stream.
12. Click Save.
13. Click Serial Interface > Tunneling.
14. On the Serial Interface Tunneling page, configure the serial port as desired.
    The port settings should match your PTZ camera settings.
15. Click Save.