Enabling PTZ for Interlogix VisioWave units - Security Center 5.8.2.0

To enable PTZ for VisioWave units in Security Center, you must create a new PTZ camera for the unit’s serial port in the Central Configuration Server.

1. Open the Central Configuration Server in Internet Explorer.
2. Click Equipment.
3. In the Equipment list, select the unit to configure.
4. Click Serial Ports.
5. Select the unit's serial port, and configure it the same as the serial configuration of the camera.
6. Click OK.
7. Click Apply in the top-right corner of the Central Configuration Server window.
   When your changes are applied, a confirmation appears in the window.
8. Click OK.
9. In the Central Configuration Server main page, click Equipment.
   
10. In the List of Video Equipment, select the unit to configure.
11. Click Serial Ports.
12. In the List of Serial Ports for Video Equipment, select the unit's serial port.
13. Click PTZ Cameras > New PTZ camera.
14. In the New PTZ Camera for Serial Port x page, do the following:
    1. In the CAMERA NAME field, type a name for the PTZ camera.
    2. In the ADDRESS NUMBER field, type the number on the PTZ camera.
    3. From the PTZ PROTOCOL drop-down list, select the PTZ protocol.
    4. In the TCP PORT field, type the port number of the input you want to control.
       The port number must be 80XX, where XX is the input number.
15. Click OK.
16. Click Apply in the top-right corner of the Central Configuration Server window.
    When your changes are applied, a confirmation appears in the window.
17. Click OK.