You can configure virtual inputs to access some actions in the camera unit's web page that are not normally supported by Security Center.
Before you begin
What you should know
To configure virtual input in Security Center:
- In Config Tool, open the Video task and select an Axis unit in the Properties tab.
- Select the Enable virtual input check box.
The unit will reconnect automatically.
After you enable the feature in Security Center, you will see several output entities in the Peripherals tab of the video unit. Each entity corresponds to a virtual input on the unit.
- Open the System task, and click General settings.
On the Actions page, create an event-to-action. For
more information, see Creating
NOTE: You can configure the web page before enabling the virtual input feature in Security Center without losing any configuration.
To configure action rules for an Axis unit:
- Open the unit's web page.
- Click .
In the Condition section, set up an action rule that
corresponds to the event-to-action created in Security
After the unit is configured, it will perform the action triggered by Security Center.