Configuring Epiphan VGA Broadcaster units - Security Center 5.9.2.0

Security Center Video Unit Configuration Guide 5.9.2.0

Applies to
Security Center 5.9.2.0
Last updated
2021-04-09
Content type
Guides > User guides
Language
English
Product
Security Center
Version
5.9

You must configure an Epiphan VGA Broadcaster unit on the unit's web page before you add it to Security Center.

Procedure

To configure an Epiphan VGA Broadcaster Lite unit:

  1. Open the unit's web page.
  2. Click Configuration > Stream Setup.
  3. From the Stream type drop-down list, select RTSP (H.264 codec).
  4. Under RTP/UDP stream, do the following:
    1. Make sure that the Enable RTP/UDP stream option is cleared.
    2. To prevent tearing during playback, select Enhanced compatibility mode.
  5. Configure any other video settings as necessary.
  6. For motion detection to work properly, set a high Bitrate value according to the resolution and frame rate you selected.
  7. Click Apply.

To configure an Epiphan VGA Broadcaster unit (firmware 2.4.0 and later):

  1. Open the unit's web page.
  2. Click Configuration > Stream Setup.
  3. From the Codec drop-down list, select H.264.
  4. To prevent tearing during playback, select Enhanced compatibility mode (h.264 slicing for RTP).
  5. Configure any other video settings as necessary.
  6. For motion detection to work properly, set a high Bitrate value according to the resolution and frame rate you selected.
  7. Click Apply.