Preparing to configure Synergis™ units - Synergis™ Softwire 10.10

Synergis™ Appliance Configuration Guide 10.10

Applies to
Synergis™ Softwire 10.10
Last updated
2019-11-11
Content type
Guides
Guides > Administrator guides
Language
English (United States)
Product line
Synergis > Synergis™ Softwire
Version
10.10

Before you can configure a Synergis™ unit, you must perform some pre-configuration steps.

Procedure

  • Read the release notes for any known issues and other information about the release.
  • Have a computer equipped with a network card, Ethernet cable, and a web browser.
  • (Optional) Have the IP address assigned by your IT department to the Synergis™ unit.
  • Configure the hardware settings (DIP switches, address dials, etc.) to their final position on the interface modules.
  • Connect the interface modules to the Synergis™ unit through the proper communication channels.
    NOTE: Because each hardware manufacturer uses a different communication protocol, all interface modules connected to the same RS-485 channel must be from the same manufacturer.
  • Physical devices (REX, door sensors, etc.) should be connected as well, but can be replaced by test switches and LEDs during the configuration phase.
    For more information, see What is Synergis™ Cloud Link?
  • Download the latest Synergis™ Softwire package from https://gtap.genetec.com.
  • Install and configure Security Center with at least one Access Manager role.
    For information about deploying Synergis™, see the Deploying your access control system.