You can use the DIP switches on the Synergis™ Cloud Link to run hardware commands.
Available DIP switch commands
There are four DIP switches on the Synergis™ Cloud Link labelled 1 to 4. To run a command, set the DIP switches as indicated in the table below and press the EC button for one second. If the code is valid, the status LEDs will flash green for the process of the command, otherwise they flash red for one second. Synergis™ Cloud Link automatically performs a software restart after you have run a command.
|OFF||OFF||OFF||OFF||Resets the Synergis™ Appliance Portal logon password to factory default (softwire).|
|ON||OFF||OFF||OFF||Resets all settings to factory default. This command has the
NOTE: The unit firmware is not affected by this command.