Cloning interface module settings - Synergis™ Softwire 11.0

Synergis™ Appliance Configuration Guide 11.0

Applies to
Synergis™ Softwire 11.0
Last updated
2021-08-24
Content type
Guides > Administrator guides
Language
English (United States)
Product line
Synergis > Synergis™ Softwire
Version
11.0

To save time on configuration, you can add new interface modules by duplicating the settings of an existing interface module, and then make changes if required.

Before you begin

If you want to clone your interface modules, but you have already created the new ones, then delete the new ones.

Procedure

  1. Click Configuration > Hardware.
  2. On the Hardware configuration page, add and configure an interface module or select one from the hardware tree as your model for cloning.
  3. Click .
  4. In the Add hardware dialog box, add all the interface modules you want to add based on the selected model, and then click Save.
    You only need to specify the physical address of each new interface module and the channel it is connected to. All other settings will be copied from the model interface module.

After you finish

Modify the settings of the cloned interface modules as required.